Flow Designer Error while creating a MS Teams Channels
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-14-2024 12:30 PM
Hi All,
I am trying to create a MS Teams Channel using Flow Designer actions.
Check the Error Screenshot:
Thank you!!
- Labels:
-
flow designer

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-14-2024 02:32 PM
Make sure your action (Create Channel) points to the correct C&C Alias. Looks like the one used in the action isn't available even - since it can't be found.
Have you gone through the Spoke setup?
If helpful or correct, please indicate so!

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2024 12:36 AM
So, the alias you're looking for is the one below.
It's the one supplied when you install the spoke. If you don't have it, it's either deleted or for some reason it wasn't installed when the plugin was installed. In that case, try a plugin repair and see if that helps you.
If helpful or correct, please indicate so!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2024 03:26 AM
Hi,
Its already there and available but still getting the error.
Thank you!!

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2024 03:12 PM
Excellent - and, please also confirm you have a Connection in there?