Progress Controller was left in running state on startup
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-02-2024 11:00 PM
I got the message "Progress Controller was left in running state on startup" in progress worker table. The job behind was cancelled after 5 hours by the system. btw: the job takes 5-6 hours and runs mostly successful in the days before.
Does anybody know this message? What does it mean?
I will always try to give a meaningful and valid answer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-02-2024 11:31 PM
Hi @Guido Bernuetz,
please check below link:
Thank you, please make helpful if you accept the solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-03-2024 01:51 AM
No, didn't help. Has nothing to do with Progress Worker.
I will always try to give a meaningful and valid answer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-09-2024 11:20 AM - edited ‎07-09-2024 11:55 AM
I just had the same issue, tho for mine there was a bug in my code and rerunning it fixed did work. Looking forward to hearing an answer to this!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎08-27-2024 07:30 AM
I am also getting this message attempting to run our ATF test suites which normally run without this message. Was this still not resolved for you Guido?
Best Regards
