- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-22-2019 08:09 AM
Hi Community,
I was following the Flow Designer tutorial on creating subflow.
I was able to get all the actions 1-3 done, but the 4th action Assign Subflow Outputs is not available in the Flow Logic.
Is there any thing I need to install or could you point out the possible cause?
Any help is appreciated.
Solved! Go to Solution.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-01-2019 11:46 AM
Well... I"ve found the solution... It's underneath the black bar with the alerts... So you cannot see it, but select it by going beneath "End".

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-01-2019 11:29 AM
Hi did you have any luck in finding a solution? I'm facing the same problem in our DEV instance. In my PDI the action is available...
Kind regards,
Gerard Wijnands

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-01-2019 11:46 AM
Well... I"ve found the solution... It's underneath the black bar with the alerts... So you cannot see it, but select it by going beneath "End".
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-08-2019 08:49 AM
Yes. Thank you for the reply. I figured it out but forgot to update the post.
It was blocked by other component.
It will be better if someone can make the dynamic list can be on top of the other elements.