Still getting SYS_ID instead of Display value in Reference
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2017 04:13 AM
Hi, I have created a new table. only 2 fields for a reference field. its not extended from any other table.
however when clicking on the lookup magnifier, it shows the sys_id values
I went into <system Definition> <Dictionary> and on the table I set the friendly string name to true
but still I only get the sys_id on lookup?
what else do I need to do?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2017 04:16 AM
Cry clearing cache once
Cache.do and your browser cache too.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2017 04:23 AM
Thanks Anurag,
Thats, not done the trick though.
Appreciate your help regardless!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2017 04:35 AM
Hiya
Do you have one of the fields set for display is True on the table? As that's which field will be shown in the list views?
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2017 04:37 AM
Hi,
Yes, there's a picture above showing my current setting.