After doing switch discovery the network adapter shows the same mac address for all the interfaces
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎02-12-2024 07:21 PM
After doing switch discovery the network adapter shows the same mac address for all the interfaces, is this right ? why this is discovering the same mac address for all interfaces.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎02-12-2024 07:35 PM
Hello @HareeshPVR,
Please refer to the link below:
https://www.servicenow.com/community/itsm-forum/discovery-mac-address/m-p/675430
Mark my correct and helpful, if it is helpful and please hit the thumbs-up button to mark it as the correct solution.
Thanks & Regards,
Abbas Shaik
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎02-12-2024 07:38 PM
I saw this link , so should I use the mentioned code in it and validate?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎02-12-2024 07:42 PM
Yes, you can test in sub-prod instances.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎02-12-2024 07:47 PM
our mid servers are in linux and i could see that WMI is being used in the code , can i use the same code for linux mid servers as well?