- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2025 11:55 AM
Hello!
I have a variable on a record producer that is hidden. I have a dropdown selection of two choices. I want this variable to show when either choice is selected. Currently it does show up but i have any issue.
If i select Choice 1, the variable shows. then i change choice 1 to choice 2 it shows fine as well. But if i go from Choice 2 back to choice 1 it becomes hidden again. I have to select "none" again then pick choice 1 for it to show again.
The UI policies that run this are different orders. Reverse if false is checked on both but if i uncheck that, it shows up period.
What am i missing here?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2025 12:18 PM
I am assuming, you are having 2 UI polices like below.
UI policy 1 :- Show variableY when Choice 1 is selected
UI policy 2 :- Show variableY when Choice 2 is selected
The conflict I can see is UI policy2 'reverse if false' will act when you unselect choice2. That will make the variable hidden when going choice2 to choice1
There are 2 UI polices acting on the same variable. We will have better results if we use only one UI policy that should act on one variable.
Use only one UI policy with condition[VariableX is oneOf (Choice1 or Choice2)] then show variable Y.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2025 11:58 AM
Hi @arohm ,
Please share the script code you have written for this, share some screen shots also.
-Thanks,
AshishKM
Please mark this response as correct and helpful if it helps you can mark more that one reply as accepted solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2025 12:07 PM
Hey Ashish,
There is no script for this. Its all done on the Record producer in the variables and UI policy tabs. Ill see if i can get some screenshots.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2025 12:12 PM
I am assuming, you are having 2 UI polices like below.
UI policy 1 :- Show variableY when Choice 1 is selected
UI policy 2 :- Show variableY when Choice 2 is selected
The conflict I can see is UI policy2 'reverse if false' will act when you unselect choice2. That will make the variable hidden when going choice2 to choice1
There are 2 UI polices acting on the same variable. We will have better results if we use only one UI policy that should act on one variable.
Use only one UI policy with condition[VariableX is oneOf (Choice1 or Choice2)] then show variable Y.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2025 12:15 PM
I realize this is probably in the wrong Forum. I will move it.