- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
3 weeks ago
Hi Team,
I'm stuck in task 02 where i cant see the create button in identification rule tab , tried a few things but still it shows the same application as like default could you please help with this
Thanks & Regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
3 weeks ago
The Identifier Rule and the 2 Identifier Entries you see are derived from the Application class (parent). If you want to add Identification rules specific to your extended class, you will have to click the Replace button on that screen, create a new Identification Rule then create new Identifier Entries. Note that when you do so , the Identifier Rule and the Entries that were there earlier (derived from the parent) will go away.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
3 weeks ago
The Identifier Rule and the 2 Identifier Entries you see are derived from the Application class (parent). If you want to add Identification rules specific to your extended class, you will have to click the Replace button on that screen, create a new Identification Rule then create new Identifier Entries. Note that when you do so , the Identifier Rule and the Entries that were there earlier (derived from the parent) will go away.
