ATF: Choice List missing Choices
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2019 04:47 PM
I am trying to validate a field in the cmdb_ci_server table leveraging ATF. For some reason, I can only get one choice. I have also included the screen shot below of choices. Any thoughts would be helpful.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-21-2019 11:49 PM
Hi,
In ATF while validating fields which are dependent it is better to do it in 2 steps as the dependent fields values can't be validated in the same step. Could you please try validating sub status in new step to check if the choices are visible.
Regards,
Venkat
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2019 06:15 AM
Hi Venkatasubramani:
Thanks for taking the time to reply. Unfortunately, this did not seem to help (see screen shot below). When I added the extra validation step, the correct options for the "substatus" field which is dependent on the "Status (hardware_status)" field did not show up.