Run button on workflow editor is disabled after publishing the workflow

[Sridhar26]

Even though the workflow has been published, not able to run the workflow as it is disabled.

Please find attached screenshot for the same.

[Anurag Tripathi]

Hi,

The "play" button on the workflow will only be available if your workflow is set to run in the Global table. This can be changed at the workflow properties, found at the top-left menu of the workflow editor.

Here is the content from SN docs

• Start: Runs the workflow. This control is only available for workflows running on the Global table that are accessible from all application scopes. To test workflows that are on other tables, insert a record into that table that meets the condition of the workflow.

Read More Here

-Anurag

[Anurag Tripathi]

Hi,

Just checking to see if this answered?

-Anurag

[Sridhar26]

Thank you, Am able to run the workflow now.

[Anurag Tripathi]

If the question is answered then please close the thread by marking my answer correct.

-Anurag