Inactive Entities not filtered out by default when creating an Issue

Ulla-Maija J_sk
Tera Expert

Hi. I just noticed that when choosing entity/entities for an Issue, by default the inactive Entities are not filtered out. Can fix it, but has it always been like this? Can you tell a good reason I would want to record an issue against inactive Entity? On Utah Patch 7.

1 ACCEPTED SOLUTION

Community Alums
Not applicable

Hi @Ulla-Maija J_sk ,

This is OOTB behaviour, as there is no Reference condition mentioned in the field, if you check the dictionary.

SandeepDutta_0-1698897187121.png

So, by Default, Entity field populates all the entities regardless of whethre it's Active or Inactive.

 

View solution in original post

1 REPLY 1

Community Alums
Not applicable

Hi @Ulla-Maija J_sk ,

This is OOTB behaviour, as there is no Reference condition mentioned in the field, if you check the dictionary.

SandeepDutta_0-1698897187121.png

So, by Default, Entity field populates all the entities regardless of whethre it's Active or Inactive.