Microsoft Intune Connector - Help
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2023 12:31 PM
Hi,
I've installed the plugins Service Graph Connector for Microsoft Intune and Microsoft intune spoke. I've followed the set up guide and had a successful connection.
However I've performed the import and the data hits our instance but doesnt sit within the CMDB so I'm a bit lost as where to go with it without customisation which may already exist. Has anyone had any success with this and any resources would be most welcome.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-23-2023 09:23 PM
Running the scheduled jobs should run the full steps of not only bringing data into the import set tables, but also running the transform(s) to bring the data to the CMDB.
Import Set Table | CMDB table |
sn_intune_integrat_computer | cmdb_ci_computer |
sn_intune_integrat_software | cmdb_ci_spkg (no SAM) cmdb_sam_sw_install (with SAM Pro) |
sn_intune_integrat_devices | cmdb_ci_handheld_computing |
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-01-2023 08:33 AM
Hi, The intune plugin shows the OOB table you can check. Scott information is correct. To verify you just go to schedule jobs under In tune and check the robust transform tab it will show the import set table details.
Suresh.