Have SCCM & JAMF only pull in Software Data / not create new computers

Joshua Lima
Tera Contributor

Hi All,

 

We have a requirement to ensure that when our Service Graph Connectors SCCM & JAMF run to have them only pull in the pertaining data to software and for them to not create any net new computers on the cmdb_computer table. They are looking to get only Software installed on computers, licenses, Total Usage time etc. So far I have gotten around this in our QA environment by setting up a business rule to do an abort when the Discovery source is the SG-SCCM / SG-JAMF or the created / updated by is the SCCM / JAMF user for any inserts.

 

With that in place, we did get all the software data we were looking for except now, when JAMF runs the remove software portion it's not actually removing a piece of software from a test machine that was uninstalled. The software still shows as installed on that machine. We haven't tested that out with SCCM but assume the same will happen. Also with the SCCM & JAMF business rules in place, we don't seem to be getting the Total Usage time for each software record.

 

Is this something that is possible to setup?

0 REPLIES 0