How to create service map for network
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2023 11:33 PM
We have a requirement where we need to create a service map for network topology.
So the client get data from the switches it travels through multiple switches and reach to end switch.
Is it possible to create a map? We have routing table populated in the cmdb and it dose have the route information. But I am not finding any way to do this?
Can I extend a pattern to trace the route?
- Labels:
-
Service Mapping

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2023 12:46 AM
See if it helps to do some start,
Regards
RP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2023 12:54 AM
Hi Rahul,
Thank you for the response. I have seen the article. We do not have servers in between. It is like taking a feed from an exchange and delivering it to the client. I want to build something like if I give a switch IP as an entry point then it should use the routing table to tell me the path.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2023 01:23 AM
OOTB i doubt its there but you can explore this but i am less hopeful in SM
If its not then you can float an idea on idea pofrtal.
Regards
RP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-16-2023 04:08 AM
In the article, the network path is shown. So it is possible. I need to find out how the path is getting populated. What do you think? @Rahul Priyadars