Exclude an IP address from any discovery

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-28-2018 12:24 PM
In SN Discovery is there a way to put list of IP#s to be excluded from any discovery that is run in the Discovery Schedule jobs. This is for all IP ranges not just one Discovery Range set. If anybody try to run a discovery in a schedule job or a quick discovery it would skip the numbers that were in that list.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-28-2018 12:31 PM
Hi
Under "Discovery IP Range". One option is there to give "Discovery Range Item Excludes".
You can give the IP address from that range.
Thanks,
Prateek

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-29-2018 05:17 AM
The problem is the IPs for these devices are all over the world at different sites and can be in multiple subnet ranges in different CIDE notations.
It can be in both a /24 and a /8. So, we need to put these exclusions so it will be any Discovery range that run on this Discovery system to exclude them.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-06-2020 12:44 PM
Hey Frank,
I have a similar requirement. Did you ever solve this issue?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-15-2018 12:07 AM
Hi Franknj,
have you resolved this??? i have also same requirement in our project.