Report Migration Steps in Detai;

[ChagantiG]

Hello Team,

I was new to Reporting/ PA, can someone help me the step by step process on how to migrate reports and check if they were migrated correctly. 

Secondly how do find the right condition while configuring reports [once I put the condition how do I judge I was using the right conditions and the data is pulled correctly, where can I learn this from.

Please help.

[Ankur Bawiskar · Accepted solution]

@ChagantiG 

Testing is similar to how you perform normal testing

Simply check in DEV if the report shows correct set of records based on your report filter conditions

Also migration is normal update set migration

If you have migrated update set from DEV to QA or QA to PROD then this should be an easy task

Update set transfers 

If my response helped please mark it correct and close the thread so that it benefits future readers.

[Ankur Bawiskar]

@ChagantiG 

sys_reports are captured in update set and can be migrated.

To verify if reports are showing correct data, please test it in DEV, QA and then deploy in PROD

If my response helped please mark it correct and close the thread so that it benefits future readers.

[ChagantiG]

How do I test it, Do we have any prescribed steps and for migration are there any steps, Please help me

[Ankur Bawiskar · Accepted solution]

@ChagantiG 

Testing is similar to how you perform normal testing

Simply check in DEV if the report shows correct set of records based on your report filter conditions

Also migration is normal update set migration

If you have migrated update set from DEV to QA or QA to PROD then this should be an easy task

Update set transfers 

If my response helped please mark it correct and close the thread so that it benefits future readers.

[Ankur Bawiskar · Accepted solution]

@ChagantiG 

Thank you for marking my response as helpful.

If my response helped please mark it correct and close the thread so that it benefits future readers.