PDI not getting waked up, I have lot of data in that.

khannaa5
Tera Contributor

PDI is not getting waked up, even after multiple refreshes, can't release as I have lot of data into that.

3 REPLIES 3

Dr Atul - LNG
Tera Patron

Hi @khannaa5 

 

I've been using PDI without any issues since this morning, but I've noticed several posts in the community about PDI being offline. Here are some points to consider:

  1. There is no support available for PDI.
  2. If you can wait, let's wait a bit longer.
  3. You can release this instance and start a new one, but you will lose your previous data. To avoid losing update sets in the future, make sure to take regular backups of your PDI.

There have been 3-4 posts in the community today about PDI failures or unavailability. Based on the responses, you might need to wait 1-2 days and hopefully, the PDI will be back online.

AndersBGS
Tera Patron

Hi @khannaa5 ,

 

as you might know, there is no support available from ServiceNow in relation to PDIs, hence you’re limited to two options:

  •  wait, it should come online again after some time.
  •  If you get tired of waiting. Release your instance and request a fresh installation. Note! Any work that hasn’t been backed up will be list for good.

 

UTUB
Tera Contributor

At least ServiceNow was kind enough to finally post a banner message for us. 

UTUB_0-1747746662681.png