How To fill Change Risk Assessment Form using ATF

rkumari · ‎10-19-2023

I am new to ATF in ServiceNow. I need help on how to fill the Change Risk Assessment form using ATF. I am trying to use Set Component Value , but it's not working.

Shaqeel · ‎10-25-2023

Check the label name, ID, Type etc..to locate the correct element.

***********************************************************************************************************************
If my response proves useful, please indicate its helpfulness by selecting "Accept as Solution" and " Helpful." This action benefits both the community and me.

***********************************************************************************************************************

Regards

Shaqeel

rkumari · ‎10-25-2023

I think its recognizing correct Id, label.

Shaqeel · ‎10-26-2023

No It is not correct.

It is showing the component value of whole List of values

What you need is one specific value.

Bring the target icon to one specific value and then observe the component value

Use this target icon to drop on specific value. ONLY ONE VALUE SHOULD BE HIGHLIGHTED.

***********************************************************************************************************************
If my response proves useful, please indicate its helpfulness by selecting "Accept as Solution" and " Helpful." This action benefits both the community and me.

***********************************************************************************************************************

Regards

Shaqeel

rkumari · ‎10-23-2023

This is how I am using Manual Page Inspector to Set Component Value, but still it's it's not working??