Discovery Source Incorrect
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-30-2022 08:20 AM
Hi
I was using IntegrationHub ETL to configure and test robust transforms created by the Service Graph SCCM Connector guided setup (3.2.1). After integration testing of the SG-SCCM Computer Identity transform, I noticed the Discovery source value was ‘SCCM’ it should be ‘SG-SCCM’ (as it was in Dev and QA). See attachment.
Any ideas why this might be?
Thanks
- Labels:
-
Service Graph Connector
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-30-2022 08:48 AM
The new discovery source is SG-SCCM for Service Graph Connector for SCCM so that is the desired discovery source.
If the values are not being updated it is likely that SCCM hasn't scanned the CI since the last time the older SCCM integration ran. The discovery source will only be updated if the scan date is more recent than whichever source scanned it last. You can view this is the sys_object_source table.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-30-2022 08:58 AM
Thank you.
Just so I'm clear; the integration test I'm referring to is the 'Run Integration' feature available in IntegrationHub used to test the transform - does your answer still apply here?
