g_form is not defined. A valid form must have g_form defined.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2023 05:47 AM
g_form is not defined. A valid form must have g_form defined.
I have added test step 'open a form(sp)' in ATF. But got the above error. How to resolve this error in ATF ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2023 06:03 AM
Hi @admin11345_ ,
Can you check the below link which has similar issue which can help you.
Please mark it helpful if it helped you.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2023 10:06 AM
Hi,
I am not sure why are you getting that error. Can you please post the test steps?
Regards
Suman P.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2023 11:16 PM
Hi @admin11345_
Could you please let us know the page, Table you are trying to open using this test step.
It is possible that you using catalog item step.
Regards
Shaqeel || ATF expert
***********************************************************************************************************************
If my response proves useful, please indicate its helpfulness by selecting "Accept as Solution" and " Helpful." This action benefits both the community and me.
***********************************************************************************************************************
Regards
Shaqeel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-14-2023 12:41 PM
Hi,
I am also seeing the g_form is not defined. A valid form must have g_form defined in ATF for Open a Form (SP). How to resolve this issue? I am trying to open sn_customerservice_case table.
