ACL not working for sn_risk_risk table

MaanasK
Tera Contributor

Hi, I am trying to create a write ACL for sn_risk_risk table, with conditions and scripts. But I'm getting the following error. Can anyone help me out?

 

1 ACCEPTED SOLUTION

Ankur Bawiskar
Tera Patron

@MaanasK 

you should be in same scope as that of the table sn_risk_risk to create ACL on that with scripts or condition

Please ensure you are in correct scope

💡 If my response helped, please mark it as correct ✅ and close the thread 🔒— this helps future readers find the solution faster! 🙏

View solution in original post

3 REPLIES 3

Ankur Bawiskar
Tera Patron

@MaanasK 

you should be in same scope as that of the table sn_risk_risk to create ACL on that with scripts or condition

Please ensure you are in correct scope

💡 If my response helped, please mark it as correct ✅ and close the thread 🔒— this helps future readers find the solution faster! 🙏

@MaanasK 

Hope you are doing good.

Did my reply answer your question?

💡 If my response helped, please mark it as correct ✅ and close the thread 🔒— this helps future readers find the solution faster! 🙏

Matthias Ferstl
Giga Guru

Hi,

 

try to change your Application Scope to the right Application of the table (that would be "GRC: Risk Management") and try again.