Flow Designer Custom Action Output Variable not populating data in Flow

[Satanik1]

Hello EXperts,

I have a custom action to populate data in a flow. Although it is showing the result when I test the custom action separately, but in flow, the output is populating empty value. But the input value is taking correct result.

Below screenshots are given:

Result:

Kindly help.

Thanks
Satanik

[OlaN]

Hi,

As far as I can see, you are sending the string "3200 | REMOTE | EXDS24" as input to your custom action.

But in your script, there is no case for handling this string.

Maybe you need an else-statement to handle all cases that doesn't match your current options?

[Satanik1]

Hi olan,

Thanks for your response.

If you see in the script, the 3200 | REMOTE | EXDS24 value is present in the first "if" condition. So ideally it should give the related mailbox value in response. Am I right ?

Thanks
Satanik

[OlaN · Accepted solution]

I can see these options in the first if statement:

"3200|MIAMI-10|EXDS24"
"3200|REMOTE-AZ|EXDS24"
"3200|MIAMI-10|EXDS24"

none of them will match the string:

"3200 | REMOTE | EXDS24"

[Satanik1]

Hi olan,

Fixed it finally. It was my fault. Actually in the flow, I have been using another data pill as the custom action input value instead of the actual one which I had to use.

But all thanks to you since your identification was also correct which made me go through my whole flow once again for any other mistakes. And I found this.

Thanks,

Satanik.