I'm facing problems while testing Flow Designer using ATF? Any views on the best practices for tetsing Flows using ATF
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-17-2020 01:51 AM
I'm facing problems while testing Flow Designer using ATF? Any views on thebest practices for tetsing Flows using ATF
- Labels:
-
Service Catalog

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-17-2020 02:09 AM
Hello Ajay,
As of this writing, ATF support for flow designer UI is not supported.
- Pradeep Sharma
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2021 09:58 AM
Hi Pradeep,
I see this was 11 months ago and was in reference to Madrid. Do you know if ATF support for flow designer is supported in Paris?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-29-2022 05:15 PM
Hi.. I created ATF for Service Catalog with Flow Designer and it is working fine. Similar catalog with Flow Designer which calls Sub-Flow and it is not working as expected. I believe Sub-Flow is not getting called correctly. Is that expected? if yes, how to create ATF for item which has sub-flow in flow designer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-17-2020 02:15 AM
Hi Ajay,
ServiceNow doesn't support ATF capability for flow designer. I checked in Orlando
There are no steps for this
you can confirm this by visiting this table
sys_atf_step_config.LIST -> Step Configurations
Possibly in coming version they may add some steps for this
If my answer solved your issue, please mark my answer as ✅ Correct & 👍Helpful based on the Impact.
Regards
Ankur
Ankur
✨ Certified Technical Architect || ✨ 9x ServiceNow MVP || ✨ ServiceNow Community Leader