Add Color to a % Speedometer PA score

[pamreid]

I am trying to add color to a speedometer where if its less than 90% its red, 90-95% is yellow and over 95% is green.  I can't seem to figure out how to do it?  I have the speedometer showing the proper % currently on the score widget.  I figure i must need to add a target or something but unsure of how to do that.  I have attached two different looks, one with a dial and one with a speedometer.  Any suggestions to make it visually appealing for either would be appreciates.

[Naveen20]

We can get to the below using the existing configuration parameters. 

Use Direction Maximize to invert colours and it will show as per your requirement.

[pamreid · Accepted solution]

But that is using a report.  I couldn't figure out how to actually calculate % between two numbers using the speedometer report.  it seems to only want to use Count, Average, Summ and count Distinct.  I was able to finally figure it out using Target and Target color Schemes.  I set the target to be 100 and then set a 3 stop light to have red, yellow and green at different intervals.  Thanks for your reply.

[Kannu Kampani]

Why doesn't this work for Quebec?

[Roland Mussel]

Sure but it was not the question i have the same. It is shitty that i not simply have a flip checkbox that low is red and high is green. It would be so easy when the tool is allowing it