service graph connector for MS SCCM- not loading all software data
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-17-2023 08:25 PM
service graph connector for MS SCCM- is not loading all software data into s/w, stagging table shows all data but final data is not there in software instance tabe. removed s/w also dont so any thing revmoed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-20-2023 01:45 PM
Hi @Ashwin27 ,
I think it will import into Software Installation table and not instance table, open the SG connector data source and see the target table to which the data is being loaded for better idea.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-21-2023 06:01 AM
its software instance table only and i find out that there duplicate line items.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-20-2023 09:55 PM
Please check if you have set reclamation rules for the software data that you are trying to pull. Without reclamation rule usage data is not imported
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-21-2023 06:03 AM
Thanks, i found out that it takes time to load all data though the process was marked as completed but still it take time to reflect data.