- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-30-2016 04:27 PM
Hi all,
I have created some catalog items. Since Most of them use the same variables , I have created a variable set. I want to hide a field for some of these items so I created a UI Policy on a variable set and in the catalog conditions I have mentioned that if the catalog item is A or B or C, run the UI Policy action to hide the field. The issue that I am facing is that the UI policy applies to all the catalog items using that variable set and not just to the few catalog items that I have mentioned in the condition. Any idea why this might be happening. I wanted to find out if there is a way to make this work without having to write a client script. Any suggestions?
Thanks & Regards,
Chetana
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-31-2016 12:02 AM
Hi Chetana,
Normally if you create a UI policy for a Variable set then it will be applicable to all Catalog items using that variable set. So in your case you have to get the catalog item name or sys_id in a variable inside the variable set and use that variable instead of 'catalog item' field in the Catalog Conditions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-09-2016 06:50 AM
I never came across an issue like this...I am using this approach in many of my catalog items.
What was the issue there??
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-09-2016 07:35 AM
no system issue, just user error
