- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2025 03:06 AM
Hi @Ankur Bawiskar
I have created the use stock variable in catalog item and also this variable only visible in RITM table once the variable is updated based on selection i need to create sctask so i have created the Flow designer but the if condition getting evaluated false ,Can you please help me this scenario
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2025 12:01 AM
@manjupawadhATry below flow logic. For Desktop type device create a similar steps using another If logic
Regards,
Siva
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2025 07:19 AM
@J Siva I have tried this below solution now its working fine, Thank you so much for your help its very useful to complete my story.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2025 12:01 AM
@manjupawadhATry below flow logic. For Desktop type device create a similar steps using another If logic
Regards,
Siva
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2025 07:19 AM
@J Siva I have tried this below solution now its working fine, Thank you so much for your help its very useful to complete my story.