- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2024 07:41 AM
When setting us up for indoor mapping I seem to have missed where is it that we can set the default for if the Location Directory defaults to Card View or Map View? I would like to set it so it always uses Map View when possible.
Thank you in advance for any nudge in the right direction!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2025 08:28 PM
The ordering of the views is done via the 'Reservable Module' (Workplace Reservation Management > Administration > Reservable Module).
1. Open your reservable module
2. Click on the 'Reservable Views' related list at the bottom of the page
3. Update the order of the available views
In the picture below you will see we have the Map view as #1, followed by Card view and finally Schedule view.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2024 05:24 AM
Hello @Travis Michigan, in our upcoming release, available November 7, we made several changes to the Location Directory experience. One of these changes is opening the map by default if a map is available. Employees can still switch between the card and map view.
Kind regards,
Arvid
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2025 08:28 PM
The ordering of the views is done via the 'Reservable Module' (Workplace Reservation Management > Administration > Reservable Module).
1. Open your reservable module
2. Click on the 'Reservable Views' related list at the bottom of the page
3. Update the order of the available views
In the picture below you will see we have the Map view as #1, followed by Card view and finally Schedule view.