Re-run CI auto attestation for attestation task

[Josh P1]

Hey all,

Is there a way to configure the attestation tasks to allow the auto-attestation/smart detection to be re-run,  even if it already completed successfully for a CMDBTASK?  (I am already familiar with cancelling the attestation and running it later.)

We have a number of areas where devices may be on and offline intermittently.  Allowing the re-run of the auto attestation multiple times for a single task, will greatly reduce the need of manual validation.

[Mannapuram]

@Josh P1 You can reassign the task to another user and they will again get chance to auto attest in the CMDB workspace portal on the task. 

[Josh P1 · Accepted solution]

That is part of it, however if the the auto attestation has already been run and accepted, there is more to it.  What I should have specified is that I need the smart detection to run again as well.

I found the answer:
There is a "related" table: sn_cmdb_ws_attestation_task_state .  Find the corresponding entry for the CMDBTASK and remove the Smart Detection Run On date and uncheck the Smart Detection Accepted.  Then perform the reassignment.  With this I can add a button or some action on the workspace variant to "reset" the smart detection and provide the ability to run auto-attest against the newly detected CIs.

Thanks,

Josh