How can I turn on "Creates controls automatically" flag?

[Oshikata1]

Hi, there!

I'm proceeding with learning how to use GRC module. I found good material in now learning.

But, during the material, I need to turn on the "Creates controls automatically" flag. But I couldn't turn on the flag. Please see following video.

I think, this is bug because I could turn on this flag in my PDI. So, if you have faced same issue, can you kindly share your solution?

Thanks in advance,

Oshikata

[Community Alums · Accepted solution]

Hi @Oshikata ,

This is working as per design and it's controlled by write ACLs below

If you want to override OOB behavior, then create your own WRITE ACL.

Other option: You could create a new control objective and make changes you need ..., map it to the policy when policy due to renew. 

Mark my answer correct & Helpful, if Applicable.

Thanks,

Sandeep

[Oshikata1]

Hi, Sandeep san,

Thank you for your advice. I tried to take procedure to setup UI action again.

Then, the checkbox starts working. I'm not sure but I missed some configurations.

Thank you for your help!

Regards,

Oshikata

[Community Alums]

HI @Oshikata ,

Glad to see my answer helped you, Kindly mark the answer as Correct & Helpful both such that others can get help.

Thanks,
Sandeep