Manually allow client errors

Manually create allowed client error entries as needed in the Allowed Client Errors table.

Avant de commencer

Role required: atf_admin, atf_test_designer, or admin

Pourquoi et quand exécuter cette tâche

You normally allow client errors directly from a test result, step result, or test log, but you can manually allow them.

Procédure

1. Navigate to All > Automated Test Framework > Run > Allowed Client Errors.
2. Click New.
3. On the form, fill in the fields.

   Tableau 1. Allowed Client Error form

   Field	Description
   Report level	Report action to take when the client error is encountered. Options include: Warning – Step & Test will report Success with Warning(s): Test steps containing the allowed client error report a status of Success with warning(s). The error message appears in the test result output, and is recorded in the test logs with the status Warning. Ignored – Step & Test will report Success: Test steps containing the allowed client error report a status of Success. The error is recorded in the test logs with an Ignored status.
   Active	Check box to enable or disable allowing a client error.
   Error message	Message of the client error you want to allow.
   Description	Description of the error you want to allow. If this client error was allowed from a test result, step result, or a test log, the test log description is copied into this field.

4. Click Submit.

Concepts associés

• Allowed client errors