Hi all What happens if "run after" discovery schedule is inactive???
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-17-2024 06:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-17-2024 06:19 AM
In ServiceNow, a Run After" discovery schedule is a configuration where one discovery schedule is set to start after the completion of another. This is typically used to ensure that only a limited set of discovery schedules run at a time.
If a "Run After" discovery schedule is inactive, it means that this particular discovery schedule will not be triggered even after the completion of the preceding schedule. In other words, the discovery process that was supposed to start after the completion of the previous schedule will not take place.
Please mark my answer as either helpful or accept my solution.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-20-2024 03:33 AM
It should not trigger.
Regards,
Pratiksha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-20-2024 03:45 AM
Hi @cosek
This discovery does not run if the Run After discovery does not finish unless the Even if canceled option is selected and the discovery is canceled.