Configure SMI-S Provider for storage Discovery

Use this procedure for configuring a standalone storage device with the required SMI-S Provider for Discovery.

Avant de commencer

Role required: admin

Procédure

1. On the storage device, if the SMI-S Provider is not present, install the SMI-S Provider software.
   The SMI-S Provider software is often part of the device management software. For more information, download the SMI-S Provider instructions from the storage provider manufacture.
2. For NetApp storage devices, install the SMI-S agent on the storage device host.
   Remarque :

   Discovery can also perform native discovery of NetApp servers without accessing the SMI-S server. See NetApp Server and Cluster discovery for more information.
3. Start the SMI-S Provider service.
4. In the SMI-S Provider or agent, configure the Discovery Interval with a synchronization rate that allows the wbem probe to receives the most current information during discovery.
   For example, for EMC storage, set the Discovery Interval.

   Figure 1. EMC provider example

   

5. On the ServiceNow instance, set up CIM credentials.
6. Create a Discovery Schedule with the IP addresses of each SMI-S Provider.
7. Facultatif : Create a Discovery behavior that uses a functionality definition with a wbem port probe to make the initial port-scanning phase (Shazzam) more efficient.
8. Run a basic IP address Discovery.