Enable CAM workflow configuration

Enable the CAM workflow configuration to use custom workflows and frameworks in CAM. This feature enables you to configure workflows beyond the default National Institute of Standards and Technology (NIST) framework and adapt CAM to your organization's specific requirements.

Before you begin

Role required: sn_irm_cont_auth.admin

Procedure

1. Navigate to All > Continuous Authorization and Monitoring > Administration > Properties.
2. In the CAM System Properties page, select Enable CAM workflow configuration.
3. In the Enable CAM Workflow Configuration pop-up, read the impact listed under Turning this property on will update your CAM experience.
   The impacts to the CAM experience when you enable the CAM workflow configuration.

   • Your current homepage widgets and layout will change.
   • Existing package flows may not work until data-migration is done.
   • Any custom workflow changes will need to be managed separately.
   • New boundaries and packages will not be affected.
   • Once enabled, this property cannot be turned off.
4. Select I will run the data migration script to complete the setup option to confirm you’ll migrate existing data after enabling the workflow configuration.
   The Confirm button is enabled only after you select this checkbox. If you select Cancel or do not select the checkbox, the property remains disabled.
5. Select Confirm to enable the property.
6. Select Save to save the system properties.

What to do next

To proceed with data migration, select Script for migrating data to cam workflow configurator link under the Enable CAM workflow configuration option.

This link is available at all times, even after the property is enabled, so you can run migration when required.

See Run migration scheduled job from Step 4 for detailed migration steps.